Chapter 4

Voice over IP

4.1 Telephony Setup

Telephony installation The SpeedTouch™ is

Use a phone cable with RJ-11 connectors to:

1Wire the SpeedTouch™ Phone port(s) to your phone(s)

2If your SpeedTouch has a black-coloured port labeled connect this port to the telephone output of your DSL phone calls with the same telephone set. In the other connections are needed.

!

!

This is only required if you still want to make phone regular telephone line.

Be aware that, if the PSTN port (if provided) is not wired telephone wall outlet or distributed filter, emergency always possible!

As distributed filters are country-specific, you cannot use everywhere.

Telephony configuration The telephony service might already have been configured on your during initial setup.

If not, follow the instructions below:

Enable the telephony service

Assign phone numbers

Configure the telephony service

38

E-DOC-CTC-20051017-0149 v1.0