Chapter 4
Voice over IP
Activating/Deactivating the services
(De)activating services on the Web pages
Before you can use a telephony service, the service needs to be activated. This might have been done during the initial setup of your SpeedTouch™.
If not, you can activate or deactivate a particular telephony service:
on the SpeedTouch™ Web pages: see “ (De)activating services on the Web pages”.
by dialling the activation code on your telephone: see “ (De)activating services on your telephone”.
Proceed as follows to activate a service on the Web pages:
1Go to the SpeedTouch™ Web pages.
2In the menu, select Toolbox > Telephony.
3In the upper right corner, click Configure.
4In the Pick a task list, click Configure telephony services.
A list of telephony services provided by your Service Provider appears:
(De)activating services on your telephone
5Select the services you want to activate.
To deactivate the service, clear the corresponding check box.
6Click Apply.
Proceed as follows to activate a service using the attached telephone:
1Take the phone off the hook.
2Dial an ‘*’ followed by the activation code. If you dial a ‘#’ after the activation code, the service will be activated instantly.
The activation code depends on your provider’s configuration. The activation codes can be found on the Telephony Services Web page.
To deactivate the service, dial a ‘#’ followed by the activation code.
3Wait for the confirmation tone, and place the phone on the hook.
The Forced FXO service cannot be activated on your phone.
44 | |
|