Connections & Setup

VCR

 

 

GROUND

PHONE

– R –

 

 

 

 

 

 

 

OUT TO TV

IN FROM ANT

 

 

 

SATELLITE IN

 

– L –

 

 

VIDEO

AUDIO

 

 

S-VIDEO

DIGITAL

LOW SPEED

 

AUDIO

DATA

 

 

 

Back Panel Jacks (in alphabetical order)

Satellite Receiver Rear Panel

This diagram illustrates each of the back panel jacks found on your digital satellite receiver. When working with cables, be sure to connect corresponding outputs and inputs (Video out to Video in, Right Audio out to Right Audio in, etc.).

For more information on the function of the back panel jacks and many other features of your digital satellite receiver, press the MENU button and select System Setup from the Main menu, then select Receiver Index.

AUDIO (R and L) Audio cables offer better sound quality than RF coaxial cables. Connect a second set of audio cables to another component, such as a VCR or stereo.

DIGITAL AUDIO Connects the satellite receiver’s audio to a Dolby Digital-capable receiver or decoder. This audio connection provides the best sound quality. Use the optical DIGITAL AUDIO output cable (SPDIF) for this receiver’s best possible sound.

IN FROM ANT Connect a standard TV antenna or cable feed to the satellite receiver using this jack. You can then switch between the satellite receiver’s signal and the TV/cable feed using the remote control’s ANTENNA button to toggle between the two.

LOW SPEED DATA This port allows you to connect your digital satellite receiver to future services and accessories as they become available. A shielded cable and additional hardware may be required.

OUT TO TV Connects the satellite receiver to your TV or VCR using RF coaxial cable. This jack provides the most basic connection, carrying average sound and video quality.

PHONE Connects the satellite receiver to a telephone line. The digital satellite receiver requires a telephone line connection to periodically communicate with your program provider.

SATELLITE IN Use to connect the satellite receiver to the satellite dish antenna.

S-VIDEOProvides better picture quality than VIDEO or RF coaxial cable jacks. If your TV has an S-Video jack, use it along with the audio jacks (S- Video only carries picture information, not sound) to connect to your TV.

VCR This jack allows the satellite receiver to control the VCR using an IR cable. The cable is attached above the VCR’s remote control sensor. This connection is required for One-Touch Record and Timer recording features.

VIDEO Provides better picture quality than the OUT TO TV jack. Connect the second VIDEO jack to another device, such as a VCR. You must also connect the AUDIO cables when using the VIDEO connection.

Chapter 1

7

Page 9
Image 9
RCA DRD455RH manual Satellite Receiver Rear Panel, Back Panel Jacks in alphabetical order