Connections and Setup
Connecting to a Personal Computer
A. Use a
B. Use a 3.5 mm stereo mini pin cable (sometimes referred to as 1/8” stereo mini pin) to connect the audio. Connect the 3.5 mm end of the audio cable to the VGA AUDIO jack on the back of the TV. Connect the other end to the Audio Output jack on the PC.
Notes: The maximum panel resolution is 1366 x 768. Be sure to set your PC to the correct monitor output setting.
The MultiTask Audio™ feature allows you to listen to the sound from the TV while the PC is connected. Go to page 17 for more information.
Viewing the PC
1.Plug in the TV (see the following section for details) and the PC, if they’re not already plugged in. Turn on the TV and the PC.
2.Press the PC INPUT button on the remote control.
Setting Up Your TV
There are several steps you need to follow before you can turn on the TV. Follow the instructions below to setup and turn on your TV.
Plug in the TV
Plug the end of the cord into the back of the TV. Plug the other end of the power cord into an appropriate wall outlet. Be sure to insert the plug completely. Do not plug into an outlet controlled by a light switch.
Put Batteries in the Remote
•Remove the battery compartment cover from the back of the remote by pushing down on and sliding off the cover.
•Insert 2 fresh “AA” batteries. Make sure the polarities (+ and
•Replace the cover.
Turn on the TV
The first time you turn on your TV you need to turn on the main power to the TV by pressing the Power button on the TV’s front panel. Then press the ON/OFF button on the TV or ON•OFF button on the remote to power on the TV.
8 | Chapter 1 |
