RCA L26WD26D warranty Mounting Your TV to the Wall, Care and Cleaning, Other Information, Chapter

Other Information

L26WD26D base

L32WD26D base

Mounting Your TV to the Wall

Caution: The wall mount must bear a minimum of five times the TV’s net weight without causing damage.

To mount your TV to the wall you need to purchase a VESA wall mount. For model L26WD26D, purchase a VESA 100 x 100, M4; and for model L32WD26D, purchase a VESA 200 x 200, M6 (100 x 100, for example, means the mounting measurements are 100mm horizontally and 100mm vertically; M4 is the type of screw that needs to be used).

1.You need to remove the base first before attaching the wall mount.

A.Place the TV facedown on a surface that is soft, yet strong enough to hold the TV.

B.Use a screwdriver to remove the screws (5 for model L26WD26D; 4 for model L32WD26D) from the holes on the back of the TV’s base as the arrows indicate to the left.

2.Prior to hanging the TV on the wall, make sure all cables are already connected to the TV since access to the jacks would be difficult once it is hung.

3.Follow the directions included with the wall mount to mount the TV to the wall.

Care and Cleaning

CAUTION: Turn OFF your TV/DVD before cleaning.

You can clean the TV/DVD as required, using a soft lint-free cloth. Be sure to occasionally dust the ventilation slots in the cabinet to help assure adequate ventilation.

The TV/DVD’s screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen. If necessary, you may use a cloth dampened with warm water. Never use strong cleaning agents, such as ammonia-based cleaners, or abrasive powder. These types of cleaners will damage the TV/DVD.

While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV/ DVD. Also, avoid placing drinks or vases with water on top of the TV/DVD. This could increase the risk of fire or shock hazard or damage to the TV/DVD.

Handling Cautions

•Before connecting other components to this TV/DVD, be sure to turn all components off.

•Don’t move the TV/DVD while a disc is being played. The disc may get scratched or broken, and the TV/DVD’s internal parts may be damaged.

•Don’t put any container filled with liquid or any small metal objects on the TV/DVD.

•Exterior influences such as lightning and static electricity can affect normal operation of this player. If this occurs, turn the TV/DVD off and on again with the POWER button, or disconnect and then reconnect the AC power cord to the AC power outlet. The TV/DVD will operate normally.

•Be sure to remove the disc and turn off the TV/DVD after use.

Formation of Condensation

•Due to sharp changes in temperature and humidity, condensation may form if warm air comes in contact with any cold parts inside the TV/DVD. When condensation forms inside the TV/DVD, it may not operate correctly. If this oc- curs, leave the TV/DVD at room temperature until the inside becomes dry and operational.

•If condensation forms on a disc, wipe the disc with a soft, dry cloth by moving the cloth from the center hole to- ward the outer edge.

Handling Discs

•Don’t touch the disc’s signal surfaces. Hold by the edges or by one edge and the hole in the center.

•Don’t affix labels or adhesive tape to label surfaces. Don’t scratch or damage the label.

•Do not use damaged (cracked or warped) discs.

40 Chapter 6