RCA PHD42600 manual Connection to an external monitor, Connecting speakers

Connections and Setup

Connection to an external monitor

This monitor is able to output video signal to an external monitor or other component from the RGB OUT jack. Connect one end of a 15-pin monitor cable to the external monitor or component and the other end to the RGB OUT jack on the back of the monitor. Then connect the Audio OUT jacks (L and R) on the monitor to the Audio In jacks on the back of your external monitor.

Note: A video signal will not be ouput from the RGB OUT jack when the main power of this unit is off or in standby.

RGB OUT

To an external monitor

Connecting speakers

Before making connections, be sure to check that the audio component’s power and the unit’s main power is off. Speaker cords, 1 for each speaker, are needed for connection. Twist the stripped ends of speaker cord about 2/3 inch (15 mm). Press down on the tab to open the terminal and insert the wire. Let go to close the tab.

Twist exposed wire strands together.

Push tab to the open position, and insert the wire. Then, let go of the tab to secure the wire in place.

Note: When making speaker connections, be sure to match the polarities (+ and –) of the speaker terminals on this unit and the corresponding terminals on the speakers. If the polarity is reversed, the sound will be unnatural and lack bass.

Chapter 1 Graphics contained within this publication are for representation only. 11