Acquiring and Fine Tuning the Signal
6.Slightly loosen the elevation nuts on the LNB support arm so you can adjust the dish up and down.
7.Adjust the elevation of the dish upward and downward until you achieve the highest possible signal strength:
Use the edge of the metal here to line up the elevation
Do not use this to line up the elevation
20 |
|
| 0 | 0 |
30 | 40 | 6 | ||
| 5 |
|
•Move the dish upward one tick mark, pause for 5 seconds, and check the signal strength.
•Move the dish downward (back to the original elevation setting) and then move down one tick mark, pause for five seconds, and check the signal strength.
Elevation
Adjustment
When setting the elevation, be sure to line up the elevation setting with the elevation indicator and not the bolt.
Elevation nut
TILT UP | HANDS OFF | TILT DOWN |
One tick mark |
| One tick mark |
8.When you achieved what you believe to be the highest signal strength (peak signal), tighten the elevation nuts on the support arm.
Ordering Programming
After you have obtained and fine tuned the satellite signal, the last step you need to complete is to call the program providers to order programming, and then review the satellite receiver’s instruction manual for information about using all of the great features it offers.
Final Installation 37
