Mounting the Mast on Solid Wood or Lap Siding
Mounting The Mast On Solid Wood Or Lap Siding
Materials Needed
2 5/16 x 3" lag screws
4 5/16 x 2" lag screws
Tools Needed
•Electric drill with a 3/16" wood bit
•Bubble level
•1/2" wrench
•3/8" wrench
•7/16" wrench
•Pencil
4 5/16" washers
Important Considerations:
•Make sure the wooden surface is structurally sound
•Do NOT mount the dish where someone might use it as a handrail.
•Do NOT mount the dish on any type of aluminum or vinyl siding.
•Do NOT mount the dish on any type of composite paneling, such as fiber board, particle board, or strand board.
•Do NOT mount the dish under an eave or overhang that may block or partially shadow the dish.
DANGER
AVOID Power Lines!
When following these instructions, take extreme care to avoid contact with overhead power lines, electric lights, and power circuits. Contact with power lines, electric lights, or power circuits may be fatal. It is recommended that the dish be located more than 20 feet from overhead power lines.
16 Mounting the Mast
