MAINTENANCE
CAUTION: ANY SAFETY SCREEN OR GUARD REMOVEDFORSERV- ICING AN APPLIANCE MUST BE REPLACED PRIOR TO OPERAT- ING THE APPLIANCE.
CLOTHING OR OTHER FLAMMA- BLE MATERIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLI- ANCE.
6)Each time the appliance is lit, it may cause condensation and fog the glass. This condensation and fog is normal and will disappear in a few minutes as the glass heats up.
Never operate the appliance without the glass properly secured in place, with broken glass or with the door open.
7)Verify proper operation after servicing.
8)Periodically check the pilot flames, there should be three strong blue flames approx. 3/4" long - 1 flame to the front burner, and 1 to the thermopile and one to the left. See diagrams below.
Correct flame pattern has two strong blue flames: 1 flowing around the ther- mopile and 1 reaching towards the rear burner (it does not have to be touching the burner).
Incorrect flame pattern will have small, probably yellow flames, not coming into proper contact with the rear burner or thermopile.
Top View of pilot flame
If you have an incorrect flame pattern, con- tact your Regency dealer for further in- structions.
WARNING
Do not spray aerosols in the vicinity of this appliance while in operation.
GOLD-PLATED TRIM
The 24 carat gold plated finish on the trim requires little maintenance, and need only be cleaned with a damp cloth. DO NOT use abra- sive materials or chemical cleaners, as they may harm the finish and void the warranty.
Clean any fingerprints off before turn- ing the unit on. If the top louvres start to discolour, check the door gasket seal and replace if necessary.
LOG REPLACEMENT
DOOR GLASS
REPLACEMENT
Your Regency stove is supplied with high temperature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replace- ment from an authorised Regency dealer only, and follow our
WARNING: do not operate appli- ance with the glass front removed, cracked or broken. Replacement of the glass should be done by a li- censed or authorised service per- son.
Bay Glass Removal
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Remove the nuts holding the glass retainers in place.
3)Remove the glass retainers (sides, top and bottom).
4)Replace the glass. The glass must have gasketing around it.
5)Reverse the previous steps, replace the retainers and fasten with the nuts but do not over tighten, as this can break the glass.
6)Replace door on the stove and check the seal.
| The unit should never be used with broken |
| logs. Turn off the gas valve and allow the unit |
| to cool before opening door to carefully re- |
| move the logs. The pilot light generates enough |
Top View of pilot flame | heat to burn someone. If for any reason a log |
| should need replacement, you must use the |
| proper replacement log. The position of these |
| logs must be as shown in the diagram under |
| Log Installation. |
| NOTE: Improper positioning of logs may |
| create carbon |
| alter the unit’s performance |
| which is not covered under war- |
| ranty. |
Flush Glass Replacement
Slide old glass out of the side frames and replace with new glass.
18 | Regency |
