MAINTENANCE
MAINTENANCE
INSTRUCTIONS
Any maintenance required accessing the glass door of the unit must be performed by an authorized service person.
1) Always unplug the power cord before |
cleaning. For relighting, refer to lighting |
instructions. Keep the burner and control |
compartment clean by brushing and vacu- |
uming at least once a year. When cleaning |
the logs, use a soft clean brush as the logs |
are fragile and easily damaged. |
2) Clean glass (never when unit is hot), appli- |
WARNING: CHILDREN AND ADULTS SHOULD BE ALERTED TO THE HAZARDS OF HIGH SURFACE TEMPERATURE AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE CAREFULLYSUPERVISED WHEN THEY ARE IN THE SAME ROOM AS THE APPLIANCE.
LOG REPLACEMENT
The unit should never be used with broken logs. Unplug the power cord and allow the unit to cool before opening door to carefully remove the logs. If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagram under Log Installation.
Note: Improper positioning of logs may create carbon
ance, louvres, and door with a damp cloth. |
Never use an abrasive cleaner. The gold |
louvres (and optional gold door) may be |
scratched if abrasives are used to clean |
them. |
The heater is finished in a heat resistant |
paint and should only be refinished with |
heat resistant paint (not with wall paint). |
Regency uses StoveBright Paint - Metallic |
Black #6309. |
3) Make a periodic check of burner for proper |
position and condition. Visually check the |
flame of the burner periodically, making sure |
the flames are steady; not lifting or floating. |
If there is a problem, call an authorized |
service person. |
4) The appliance and flueing system must be |
inspected before use, and at least annu- |
ally, by an authorized field service person, |
to ensure that the flow of combustion and |
ventilation air is not obstructed. |
During the annual service call, the burners |
should be removed from the burner tray |
and cleaned. Replace the embers - do not |
block the burner ports. |
5) Keep the area near the appliance clear and |
free from combustible materials, gasoline |
and other flammable vapours and liquids. |
6) Verify proper operation after servicing. |
CAUTION: ANY SAFETY SCREEN ORGUARDREMOVEDFORSERV- ICING AN APPLIANCE MUST BE REPLACED PRIOR TO OPERAT- ING THE APPLIANCE.
CLOTHING OR OTHER FLAM- MABLE MATERIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLIANCE.
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. IMMEDIATELY CALL AN AUTHORIZED SERVICE TECHNI CIAN TO INSPECT THE APPLI- ANCE AND TO REPLACE ANY PART OF CONTROLSYSTEMAND ANY GAS CONTROL WHICH HAS BEEN UNDER WATER.
DOOR GLASS
REPLACEMENT
Your Regency stove is supplied with high tem- perature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replacement from an authorised Regency dealer only, and follow our
WARNING: do not operate appli- ance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or authorised service person.
Flush Glass Replacement
Slide old glass out of the side frames and replace with new glass.
GLASS GASKET
If the glass gasket requires replacement use glass gasket (Part #
Regency IG34 Gas Inbuilt Fireplace | 25 |