Regency P131 Framing And Finishing, Note These units are non-loadbearing, C A B, P121-2- See Thru

INSTALLATION

FRAMING AND FINISHING

1)For ease of installation, frame your fi replace after it is positioned and the vent system is installed. Remember to install the top standoffs. See the "Unit Assembly Prior to Installation" section. Use 2x4's and frame to local building codes.

CAUTION: Verify your fireplace dimensions, framing methods and finished wall facing details before framing. Determine the total thickness of facing material - drywall plus ceramic tiles, slate, etc. Allow the finish surface to be flush with the front or side of the unit. Total facing thickness can vary from 1/2" (13mm) to 1-1/4" (32mm) thick.

2)When locating your appliance on an exterior wall or in a chase, apply a vapour barrier and drywall, as per local building codes. DO NOT

INSULATE THE FIREPLACE ITSELF.

CAUTION: The unit does not have to be completely enclosed in a chase. The clearance on top of the unit is 0" to the standoffs so combustible building materials can be laid directly on top of the standoffs. You must maintain clearance from the vent to combustible materials for both rigid and flex, see Vent Clearances in the "Clearances" section.

Framing Dimensions

	P121-2 (See Thru)	P131-2 (Pier)	P121LC-2 / P121RC-2
			(Corner Unit)
A	25"(635mm)	25"(635mm)	26-13/16"
	minus two times	minus two times	minus one time
	the fi nishing	the fi nishing	the fi nishing
	material thickness*	material thickness*	material thickness*
B	42-1/2"(1080mm)	42-1/2"(1080mm)	42-1/2"(1080mm)
C	46-3/4"(1187mm)	45" (1143mm)	45"(1143mm)
		minus one time	minus one time
		the fi nishing	the fi nishing

* Finish material thickness includes: drywall, ceramic tile, slate, etc.

P121-2 - See Thru P121LC-2 - Corner Unit

P131-2 - Pier P121RC-2 - Corner Unit

C

A

B

Note: These units are

non-load bearing.

Regency® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace 11