Regency P121 Log Installation, Push back side of the left end of the log up, 326, Tab on Burner

INSTALLATION

LOG INSTALLATION

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

Log Kit # 360-930 contains the following pieces:

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Place Log 326 on the front right side of the burner. Ensure that the notches on the far right side of the log fi t into the grate posts. Push back side of the left end of the log up against the tab on the burner.

a)326 Front Right Log

b)327 Front Left Log

c)328 Middle Right Log

d)329 Middle Left Log

e) Embers 902-154

Please note that there are 2 of each log. This log set is mirrored front and back.

327

326

329328

The 3-digit numbers (ie. 327) are molded into the rear of each log.

The image below shows all of the logs in place.

326

Push back side of the left end of the log up

against the tab on the burner.

Repeat step 2 on the opposite side of the burner.

326

326

328	326	329	327	3) Place Log 327 on the front left side of the burner. Position the right
				end of the log in between the two tabs and the left end of the log into

the grate post.

327

Tab on Burner

327 329 326 328 Grate Post

28 Regency® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace