INSTALLATION
25)Locate the ground lug at the receptical box, left of the unit.
26)Connect one end of the supplied green ground wire to the lug with the nut and washer from the kit.
Ground
wire from
kit
29) Plug the DC spark generator wires to the | 33) Find a location which is not too hot and is |
DC Sparker. | easy to reach for changing the |
| battery. |
| 34) Tie up the loose wire with the wire clip. |
30)Connect the ground wire to the DC Sparker mounting bracket.
35) Check for gas leaks.
36) Check inlet and outlet pressures.
37) Check operation of fl ame control.
38) Check for proper fl ame appearance and glow on logs.
27)Install the 1/2" bushing to the heat shield.
31) InstallthesuppliedbatteryintotheDCSparker Box by opening the battery compartment.
NOTE: The battery in the DC Sparker Box will need to be replaced annually.
Installer Notice:
These instructions must be left
with the appliance.
28)Run the other end of the ground wire and DC spark generator wires through the bushing on the heat shield.
Heat Shield
Battery
Compartment
32)Mount the heat shield to the DC Sparker. Secure into place with the velcro, which is provided in the kit.
26 | Regency® |