Regency U37-LP1 Installation, Vertical Termination With Co-Linearflex System, Required Parts

INSTALLATION

VERTICAL TERMINATION WITH

CO-LINEAR FLEX SYSTEM

THE APPLIANCE MUST NOT BE CONNECTED TO A CHIMNEY FLUE SERVING

A SEPARATE SOLID FUEL BURNING APPLIANCE.

This appliance is designed to be attached to two 3" (76mm) co-linear aluminium fl ex running the full length of the chimney. See the Venting Ar- rangements chart in the "Rigid Pipe Venting - Vertical Terminations" section for minimum and maximum fl ue lengths.See chart below for minimum distances from roof. Periodically check that the vent is unrestricted.

Masonry chimneys may take various contours which the fl exible liner will accommodate. However, keep the flexible liner as straight as possible, avoid unnecessary bending.

The Air Intake pipe must be attached to the inlet air collar of the termination cap.

Required Parts:
Part #	Description
946-529	Co-linear DV Vertical Termination Cap
948-305	3" Flex - 35 ft.
640-994	U37 Rigid Pipe Adaptor
946-563	Co-Axial to Co-Linear Adapter Kit
	which contains the following:
	Co-linear Flex Adapter (270-585)
	Outer Pipe (946-257)
	Inner Pipe Adapter (946-219)
Alternate Approved Caps		Co-linear DV
980	Vertical Termination Cap
991	High Wind Cap	Vertical Termination
		Cap # 946-529
923GK	3" Co-linear Adapter
	with fl ashing
		Check local
		codes whether
		a continuous
		length is re-
		quired or if	Flex Liner
		certified joiner
		kits may
		be used.
		#948-305
		(35 ft)
		Exhaust
		Flue

U37 Rigid Pipe

Adaptor

Part # 640-994

Air Intake

	Co-Linear
	Flex
	Adapter
	with Kit#
	946-563
Inner Pipe
Adapter	Outer
with Kit#
946-563	Pipe
	with Kit#
	946-563

14 U37-1 Regency® ULTIMATE Rear Vent Direct Vent Freestanding Gas Stove