MAINTENANCE
FAN MAINTENANCE | 4) Lift fan off of the 2 pins, tip back and pull | |||||
| ||||||
| through the opening. Disconnect the green | |||||
If your fan requires maintenance or replacement, | ground wire from the right side of the fan as | |||||
soon as you can reach it. | ||||||
access to the fan is through the plate on the rear | ||||||
|
|
|
|
| ||
wall of the fi rebox. NOTE: the unit MUST NOT |
|
|
|
|
| |
be operated without the fan access panel |
|
|
|
|
| |
securely in place and correctly sealed. |
|
|
|
|
| |
|
|
|
|
| ||
IMPORTANT: These fans collect a lot of dust from within your home. Ensure you maintain these fan motors on a regular basis by vacuuming out the fan squirrel cages,aroundthemotor,andaroundthe grills on the back of the stove.
REMOVING VALVE
If your valve requires maintenance or replace- ment, use the following instructions:
Note: Alwayscloseoffthegassupplybefore removing the valve.
1)Open front pedestal door. You may want to put a soft cloth on the base of the unit so that when the pedestal door is open it doesn't scratch the paint. See diagram below.
IMPORTANT
Disconnect power supply
before servicing
WARNING:
Electrical Grounding Instructions This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded
To Remove Fan:
1)Unplug or disconnect power source to stove.
2)Remove the rear 
access panel on the back of the stove. The fan can only be accessed from the back of the stove.
3)Unclip the black and white wires from the fan mo- tor.
Replacing Fan:
Reverse the above steps (1 - 4). Make sure the fan wires and the ground wire are reattached.
Hint for pushing fan down onto pins - rub a bit of dish soap on the grommet so it will slide more easily onto the pin. Check to make sure the fan is seated properly on the pins - try to move the fan back and forth, there should be no noise, if there is check that the grommets haven't come loose.
2) Undo the six screws holding the control panel
in place.
3) Disconnect all wires from the back of the con- trolpanelandthenremovepanel. Youshould lay the panel on a soft cloth so it doesn't get marked up. See diagram above.
30 |
