Problem | Possible Cause | Solution |
|
|
|
| There is excessive leak. | Adjust position of mask and |
|
| headgear. |
| Plugs may be missing from | Replace them. |
| ports on mask. |
|
| Air tubing not connected | Connect firmly at both |
| properly. | ends. |
| Air tubing kinked or | Straighten or replace. |
| punctured. |
|
| There is a large impedance | Press the Start/Stop key. |
| (eg, antibacterial filter, |
|
| oxygen connector) in the air |
|
| circuit. |
|
|
|
|
VPAP III | SmartStart/Stop is disabled. | Enable SmartStart/Stop. |
stop when you remove |
|
|
your mask. | Use of a full face mask. |
|
|
| SmartStop does not work |
|
| with a full face mask. |
|
|
|
SmartStart is enabled | Incompatible humidifier or | Use only equipment as |
but the VPAP III | mask system being used. | recommended and supplied |
does not stop |
| by ResMed. |
automatically when |
|
|
you remove your mask. |
|
|
|
|
|
Displays error | Component failure. | Return your VPAP III |
message: |
| for servicing. |
SYSTEM ERROR |
|
|
Call service! |
|
|
|
|
|
Excessive motor noise. | Component failure. | Return your device for |
|
| servicing. |
|
|
|
Display error message: | You have experienced | Check that your air tubing is |
High leak in last | excessively high leak levels | connected properly and that |
session. | during the night. | your mask does not leak |
|
| excessively. |
|
| Use the |
|
| to help you to fit your mask |
|
| properly. |
|
| If this message appears |
|
| again, contact your clinician. |
|
|
|
36