RGB Spectrum Quadra User's Guide System Timing, Following topics are outlined in this section

INTRODUCTION TO

TIMING

. . . . . . . . .

I N S T A L L A T I O N A N D S E T U P.

. System Timing ..

.

With the IP address and port properly entered, the Telnet window opens and Quadra responds with the product name and copyright notice as shown in the sample below.

Figure 2-5.Quadra Login (Sample)

4.To confirm the connection, in the Telnet window type:

ID

…and press Enter. Quadra responds with a variety of product details including the unit’s IP settings.

You can now control Quadra directly by issuing ASCII commands from the Telnet terminal. Refer to Chapter 4, “Command Line Interface” for a complete command list.

Note	To close a Telnet session, type EXIT or use the keystroke
	sequence “Control + D.”

5.Please continue with the “System Timing” section.

SYSTEM TIMING

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

The following topics are outlined in this section:

•Introduction to Timing

•Output Timing

•Advanced Output Timing

•Input Timing

For the best visual results with Quadra, the timing parameters of a signal must match the display device. Please note:

•For each of Quadra’s four output channels, each channel’s output settings should match the connected display.

•For each of Quadra’s four graphics inputs, Quadra’s input settings should match the characteristics of the input signals.

350-7951 Quadra User’s Guide 19