Frames
Installations using 17.5° “A” Frames
This
The ‘A’ Frame kit is for use where side pitch, against pitch and low or flat
roof installations are required. The ‘A’ Frame kit is provided with 17.5° angled side frames. Fixing nails, bolts, screws and flashing material are not normally supplied by Rheem except by special arrangement. The weight of the assembled frame is approximately 110 lbs. The installations described below are for an 80 gallon, 2 collector system, however, the same procedure is applicable for all models.
Description | 47 Gallon | 80 Gallon |
5/16" hex set screw | 16 | 18 |
|
|
|
5/16" washer | 6 | 6 |
|
|
|
5/16" nut | 20 | 22 |
|
|
|
5/16" bolt (2" long) | 4 | 4 |
|
|
|
Coach screws | 2 | 2 |
|
|
|
Pipe leg | 2 | 2 |
|
|
|
'U' Bracket | 2 | 2 |
|
|
|
Brace angle | 2 | 2 |
|
|
|
Stainless steel straps | 2 | 2 |
|
|
|
Tank clamp | 2 | 2 |
|
|
|
17.5 Frame | 2 | 2 |
|
|
|
Tank Collector Rail | 1 | 1 |
|
|
|
Collector clamps | 2 | 4 |
|
|
|
Collector Fixing Rail, Single Collector | 1 | 0 |
|
|
|
Collector Fixing Rail, Two Collectors | 0 | 1 |
|
|
|
Baseplate | 2 | 2 |
|
|
|
The ‘A’ Frame kit consists of:
Brace Angle
Tank Clamp
(2)
17.5° Frame
Collector Clamps
17.5° Frame
Collector Fixing Rail
36