ASSEMBLY

Driveline Clamp Cone Yoke Operating Instructions

Remove the two 5/8”-11 bolts from the driveline clamp yoke and slide yoke onto the shaft and align holes with annular groove of gearbox shaft. Reinstall bolts and tighten to 130 ft.-lb. torque. Push and pull the driveline to ensure it is securely attached to the shaft. Regularly check the driveline yoke to ensure a tight connection. To remove the yoke, remove the bolts and pull yoke off the shaft.

Mower is now assembled and ready for pre-delivery checks.

FN180/FN120 01/11

Assembly Section 3-9

© 2011 Alamo Group Inc.

ASSEMBLY

Page 101
Image 101
Rhino Mounts FN120, FN180 manual Driveline Clamp Cone Yoke Operating Instructions