Rhino Mounts FN120, FN180 manual Operation

OPERATION

Uneven Cut	Excessive ground speed.	Reduce ground speed.
	Blades worn, dull, or bent.	Replace blades.
		(Refer to "Maintenance" section).
	Mower not level side to side.	Adjust. (Refer to "Assembly" section)
	Improper height adjustment.	Adjust Mower height.
		(Refer to "Assembly" section)
	Low tractor tire pressure on one side. Adjust tire pressure.
		(Refer to your tractor
		operator's manual)
	Turning too fast.	Reduce ground speed when turning.
	Tractor tires push grass down.	Adjust your tractor wheel spacing.
		(Refer to "Operation" section)
	Damaged Mower pan.	Repair or replace as necessary.
Uncut Material	Excessive ground speed	Reduce ground speed.
	RPM too low	Use full PTO speed.
		(Refer to your tractor
		operator's manual)
	Improper blade for direction of cut.	Install blades so rotation is correct.
Poor Shredding	Excessive ground speed.	Raise the front of Mower relative to the
		rear to hold and circulate material
		longer. (Refer to the "Operation
		Section-Setting the Mower-Setting
		Deck Height”) Reduce ground speed.
	Cutting too high.	Lower cutting height. (Refer to the
		"Operation Section-Setting the Mower-
		Setting Deck Pitch”)
Windrowing	Material heavy and lush.	Raise the front of Mower relative to the
or Uneven		rear. (Refer to the "Operation Section-
Material Distribution		Setting the Mower-Setting Deck
		Height”)
	Excessive ground speed	Reduce ground speed.
	Conditions too wet.	Wait for conditions to dry. Reduce
		ground speed.

FN180/FN120 01/11 Operation Section 4-49

© 2011 Alamo Group Inc.

OPERATION