MAINTENANCE
MAIN CV DRIVELINE SHIELD SERVICE INSTRUCTIONS
1.Clean and grease bushing groove before the bushing is placed in the groove. Grease any remaining bushings in guard.
2.Slide guard half over driveline and insert bushing tabs into the openings in the guard.
3.Turn the bushing until it engages into the guard.
4.Push Easy Lock clip into position. The bushing and guard are now secure.
5.TO REMOVE GUARD - Use screwdriver to release Easy Lock clip. Turn the bushing to disengage from the guard and remove guard. Figure
MPORTANT! Check that Guard Missing decal on steel tube under inner guard and Rotating Driveline Decal are firmly affixed, undamaged and readable. If not, replace.
FN180/FN120 01/11 | Maintenance Section |
©2011 Alamo Group
