OPERATION
Engagement Check Procedure
•With the driveline attached, position the mower to the point where the telescoping driveline is at its maximum extension. Completely shut down the tractor and secure in position.
•Mark the inner driveline shield 1/8” from the end of the outer shield.
•Disconnect the driveline from the tractor and separate the two driveline halves.
•Measure the distance from the mark to the end of the inner profile. This length is the amount the driveline profiles were engaged.
•If the engaged length is less than 6”, the shaft is considered too short and should be replaced with a longer shaft.
Consult an authorized dealer to purchase the required driveline length.
NOTE: If the driveline cannot be shortened and still maintain the required profile engagement, the operator must be made aware of terrain conditions and avoid situations which pose a potential problem to avoid damaging the driveline or move drawbar to 16” or 20” position for required clearance.
FN180/FN120 01/11 | Operation Section |
© 2011 Alamo Group Inc.
