Laser Facsimile
Special setup for the copy
Setups done through this menu become the device default setups after you confirm.
When the quality of the printing is not Important satisfying, you can proceed to a
calibration with MENU 80.
BEGIN. OF SHEET
y
x
END OF SHEET
Analysed area
Resolution setup
The RESOLUTION parameter allows you to setup the photocopy resolution.
841 - ADVANCED FCT/COPY/RESOLUTION1 Choose the resolution with the buttons | or | ||
according to the following table: |
| ||
Parameter |
| Signification |
|
|
| ||
|
|
|
|
|
|
|
|
DRAFT |
| Low resolution. |
|
|
|
| |
AUTO |
| Standard resolution for documents | |
| containing text and graphics. |
| |
|
|
| |
|
|
| |
QUALITY |
| Optimal resolution for documents | |
TEXT |
| containing text. |
|
|
|
| |
PHOTO |
| Optimal resolution for documents | |
| containing photographies. |
| |
|
|
| |
|
|
|
|
2Confirm your choice by pressing the OK button.
Note | You can also setup the resolution | ||
by pressing the | button. | ||
| |||
Zoom setup
The ZOOM parameter allows you to reduce or enlarge an area of a document by choosing the origin and the zoom level to apply to the document, from 25 to 400 %.
842 - ADVANCED FCT/COPY/ZOOMING1 Enter the desired zoom level with the Alpanumerical keyboard or choose among predefined values with the buttons and .
2Confirm your choice by pressing the OK button.
Analysis origin setup
If you want, you can change the origin of the scanner.
By entering new values for X and Y in mm (X < 210 and Y < 280), you move the analysed area as shown on the diagram below.
1Select the X and Y coordinates with the buttons or .
2Setup the desired coordinates with the digital
keyboard or the buttons and , confirm your choice by pressing on the OK button.
Contrast setup
The CONTRAST parameter allows to choose the photocopy contrast.
845 - ADVANCED FCT/COPY/CONTRAST1Setup the desired level of contrast with the buttons
and , confirm by pressing the OK button.
2You can also directly setup the desired contrast
with the 
button, press several times on this button until the desired setup without using the Menu 845.
3Quit this menu by pressing the 
button.
Luminosity setup
The LUMINOSITY parameter allows to lighten or darken your original document.
846 - ADVANCED FCT/COPY/LUMINOSITY1Setup the desired brightness with the buttons and .
2Confirm your choice by pressing the OK button.
3Quit this menu by pressing the 
button.
Paper type setup
851 - ADVANCED FCT/SCAN. & PRINT/PAPER TYPE1Select the paper NORMAL or THICK that you use
with the buttons and .
2Confirm your setup by pressing the OK button.
3Quit this menu by pressing the 
button.
Paper tray selection
The Automatic selection can have two meanings depending on the paper format defined on the paper trays. The following table describes the different cases.
- 20 -