Ricoh PJ WX3231N, PJ X3241N Adjust projector placement angle, Adjust the screen size and focus

Notes

•When [Auto input search] is set to [Off] in the Default setting 1 menu p.42 , the Input select menu appears if you press the INPUT button. The factory default setting is [On].

•If the projector is in network input mode and no image is projected after you press the INPUT button, check that the connected equipment is working, and press the INPUT button again.

•If no signal is being output from the connected equipment, pressing the INPUT button does not change the input and “There is no other input signal.” message will appear.

5Adjust projector placement angle.

You can adjust the placement angle and the height of the projected image using the foot adjuster.

1Lift up the front of the projector to the desired angle, then press the foot adjuster release button upward.

The foot adjuster extends. Release the button to lock the position.

2To fine adjust the angle, twist the foot adjuster.

•To stow the foot adjuster, hold up the projector while pressing the foot adjuster release button, then slowly lower the projector.

Operations

Note

•When [Auto keystone] is set to [On] in the Default setting 1 menu, the keystone distortion will automatically be corrected based on the projector placement angle. If you do not desire the automatic keystone correction, set [Auto keystone] to [Off].

6Adjust the screen size and focus.

1Use the zooming lever to adjust the screen size.

2Use the focusing lever to adjust the focus.

7Adjust the volume with the buttons.

The speaker volume can be adjusted when an audio signal is being input.

Front

29