ASSEMBLY
MOUNTING BEVEL SCALE TO SAW TABLE
See Figure 23.
nLocate the following items:
2 flat head screws, (M5 x
2 washers, (M5)
2 hex nuts, (M5 x 0.8)
1 bevel scale
1 saw table
nAlign bevel scale on the inside edge of the saw table with the text facing out. Insert the screws through the table and bevel scale as shown.
nInstall a washer and nut. Tighten
INSTALLING BEVEL SCALE INDICATOR
See Figure 24.
nLocate the following items:
1 scale indicator
1 pan head screw, (M5 x
nInsert screw through the slot in the scale indicator and into the trunnion support. Tighten.
MOUNTING THE SAW TABLE TO SAW BODY
See Figures 25 - 26.
PAN HEAD
SCREW
POINTER
SAW TABLE
TRUNNION
SUPPORT
SAW BLADE
U | L L |
P |
|
Fig. 24
THROAT PLATE
nLocate the following items:
1 saw table
2 lock knobs
nTo mount saw table, remove throat plate and pull table pin out from the table. Rotate saw table 90° and guide saw blade through slot in saw table.
n�Rotate saw table back and place table screws into trunnion support. Attach using lock knobs.
WARNING:
Unit is shipped with blade installed. Do not plug in or operate unit unless the blade is adjusted and aligned per section titled “Installing and Adjusting the Blade”. Failure to do so could result in possible serious personal injury.
FLAT HEAT | SAW TABLE |
SCREWS |
|
10° | 0° |
|
| ° | |
| 15° | |
| 30° 45 |
LOCK KNOBS | TABLE PIN | Fig. 25 |
|
| SLOT IN |
SAW TABLE |
| SAW TABLE |
TABLE | 10° | 15 | ° 30° 45° |
|
| 0° |
|
SCREWS
SAW
BLADE
TRUNNION
SUPPORT
10° | 0° |
|
15°
30°
45°
HEX NUTS
U | L L |
P |
|
LOCK KNOBS
BEVEL SCALE | WASHERS | Fig. 23 | Fig. 26 | |
|
|
|
|
|
20
