OPERATION
AVOIDING INJURY
nMake sure saw is level and does not rock. Saw should always be on a firm, level surface with plenty of room for handling and properly supporting the workpiece.
nTurn saw off, remove switch key, and unplug cord from the power source before moving the saw.
nDo not remove jammed cutoff pieces until blade has come to a full and complete stop.
nChoose the right size and style blade for the material and type of cut you plan to do.
nMake sure that the blade teeth point down toward the saw table, that the blade guides, thrust bearings, and blade tension are properly adjusted, that the blade guide knob is tight, and that no parts have excessive play.
nTo avoid accidental blade contact, minimize blade breakage, and provide maximum blade support, always adjust the blade guide assembly to just clear the workpiece.
nUse only recommended accessories.
nWith the exception of the workpiece and related support devises, clear everything off the saw table before turning the saw on.
nProperly support round materials such as dowel rods or tubing because they have a tendency to roll during a cut causing the blade to “bite”. To avoid this, always use a “V” block or clamp workpiece to a miter gauge
nBefore removing loose pieces from the saw table, turn saw off and wait for all moving parts to stop.
LOCKING THE SWITCH
See Figure 37.
nWait until the saw has come to a full and complete stop.
nPlace the switch in the OFF (O) position, remove the switch key from the switch assembly. Store key in a safe place.
BEFORE LEAVING THE SAW
See Figure 37.
n Wait until the saw has come to a full and complete stop.
nPlace the switch in the OFF (O) position, remove the switch key from the switch assembly. Store key in a safe place.
nUnplug the saw from the power source.
TO INSTALL
SWITCH KEY
ON | P |
|
|
I | U | P | OFF |
L | U | ||
| L | S |
|
|
| H |
|
SWITCH KEY
SWITCH
ON | P |
|
|
I | U | P | OFF |
L | U | ||
| L | S |
|
|
| H |
|
ON
ON | P |
|
| |
I | U | P | OFF | |
L | U | |||
| ||||
| L | S |
| |
|
| H |
|
OFF
| ON | P |
|
|
TO REMOVE | I | U | P | OFF |
L | H | |||
|
| U |
| |
|
| L | S |
|
SWITCH KEY |
|
|
|
|
OFF 
Fig. 37
26
