ADJUSTMENTS
nRotate guard under the saw table back to a closed position and tighten screw.
nClose upper and lower covers.
nReplace throat plate and table pin.
nAdjust blade guide assembly as described in the following section.
ADJUSTING BLADE GUIDE ASSEMBLY
See Figure 42.
To prevent the blade from twisting or breaking, the blade guide assembly should always be set approximately 1/8 in. (3 mm) above the workpiece.
n Turn the blade guard adjustment knob counterclockwise |
to unlock the blade guide assembly. |
n As a guide, use a scrap piece of the same wood you are |
about to cut to set the height of the blade guide assembly. |
Adjust the blade guide assembly by raising or lowering. |
n Lock blade guide assembly in place by turning the blade |
guard adjustment knob clockwise. |
ON | P |
|
|
|
I | U | P | O | FF |
LL | U | |||
|
| HS |
| |
|
|
| O | |
10° |
|
0° |
|
15° | 30° 4 |
LOCK
UL
P L
UNLOCK
TO RAISE
TO LOWER
n Always lock the blade guide assembly in place before |
turning on the band saw. |
WARNING:
Maintain proper adjustment of blade tension, blade guides, and thrust bearings. Failure to do so could result in possible serious personal injury.
SET BLADE GUIDE ASSEMBLY APPROXIMATELY |
|
1/8IN. (3 MM ) ABOVE WORKPIECE | Fig. 42 |
29
