RIDGID BS14002 manual Mounting the Switch BOX, Mounting the Dust Chute

ASSEMBLY

MOUNTING THE SWITCH BOX

See Figure 20.

nLocate the following hardware:

2 pan head screws (M5 x 0.8-12)

2 lock washers (M5)

nMount switch assembly to frame as shown using pan head screws. Thread screws into band saw chassis using a Phillips screwdriver.

MOUNTING THE DUST CHUTE

See Figure 21.

nLocate the following items:

2 pan head screws (M6 x 1)

1 dust chute

nOpen lower blade guard cover and install dust chute pointing down. Thread pan head screws from the inside of the lower blade guard cover into the dust chute.

nClose lower blade guard cover.

MOUNTING THE TABLE TRUNNION SUPPORT TO BAND SAW

See Figure 22.

nLocate the following items:

2 hex head bolts (M8 x 35)

2 lock washers (M8)

1 table stop bolt (M8 x 80)

1 nut (M8)

1 trunnion support

nPlace trunnion support on saw body and align using pins mounted as shown.

nThread hex head bolts into band saw using lock washers. Tighten.

nThread hex nut half way onto table stop bolt. Thread table stop bolt into trunnion support.

PAN HEAD

SCREWS

DUST CHUTE

LOWER BLADE

GUARD COVER

Fig. 21

TABLE STOP

BOLT

HEX HEAD

BOLTS

HEX NUT

LOCK

WASHERS

TRUNNION

SUPPORT

SAW

BLADE

ON I

P U L L

P U S H

OFF

SWITCH
ASSEMBLY		SAW BODY
		PINS
PAN HEAD		Fig. 22
SCREWS	LOCK
	WASHERS
		Fig. 20

19