Supporting Oscillating Edge Belt/ Spindle Sander to Sawhorses
The sander has provisions for being sup- ported by sawhorses. The sawhorse can be built with the crosspiece either vertical or horizontal. Make sure the sawhorses are secure.
Alignment
Squaring Front Table
WARNING: To reduce the risk of injury from accidental start, make sure tool is unplugged before aligning.
Tools Needed
1.Use a combination square to check the angle of the front table with the sanding belt. (NOTE: Combination square is not supplied.)
2.If the front table is not 90° to the sand- ing belt:
a.Use the hex wrench provided and “back out” both #10 set screws located on each side of the table.
b.Loosen the front table lock knob and adjust the front table 90° to the sand- ing belt.
c.Tighten the front table lock knob.
d.Adjust both set screws to contact the front table.
3.Adjust detent if necessary
a.Loosen the two pan head screws that secure the detent.
b.Adjust detent so that it engages the notches in the bracket table lock.
c.Tighten the two pan head screws.
Combination Square
Combination Square Must be True
Draw Light Line on
Board Along This Edge
Straight Edge of Board
3/4" Thick, This Edge Must
Be Perfectly Straight
Should be no Gap or Overlap when Square
is Flipped Over in Dotted Position
Combination | Sanding |
Square | Belt |
Front
Table
Bracket 
Table Lock
Table | #10 |
| Set |
| |
Lock Knob |
|
| |||
| Screw |
| |||
Detent |
|
|
|
| |
Pan Head | |||||
| |||||
| Screws | ||||
17
