Assembly
NOTE: The sander is preassembled except for the attachment of the rubber feet.
Mounting Rubber Feet To Base
Place the sander directly on the table sur- face.
1.From the parts bag locate the four rub- ber feet.
2.Place the sander on its side so the bot- tom of the base is facing toward the front.
3.Locate the four holes in each corner of
the base and place one of the rubber |
|
feet in each of these holes. | Rubber Feet |
|
4.Position sander in the upright position and apply pressure in the downward position to ensure the feet are inserted securely.
CAUTION: To reduce the risk of injury from tool movement, the supporting surface where sander is mounted should be examined carefully after mounting to insure no movement during use can result. If any tipping or walking is noticed, secure to workbench or supporting surface before oper- ating sander.
Parts Storage
On board storage has been provided for all washers, spacers, drums, sleeves and hex “L” wrenches. All front loaded parts can be protected from incidental dislodg- ing by lowering the table all the way down until it rests against the base and tighten- ing the knob.
Storage for the sanding belt assembly and table insert is provided in the pocket on the rear of the base.
12
