RIDGID K-40B, K-40G PF manual Machine Storage Service and Repair, Autofeed

K-40 Drain Cleaner

Autofeed

A drop of grease to the following areas once a month will extend the life of the Autofeed unit and keep it well main- tained.

a. Top of Large Top Adjustment Screw

b. Threads on Bottom of Top Adjustment Screw

c. Outside Diameter of Top Roller Holder housing

There are no grease fittings to worry about, however, the autofeed will accumulate dirt, grease and debris over time. It is a good idea to periodically remove the autofeed unit and clean with cleaning solvent and a firm brush.

It is also a good idea to apply a light grease once a week, to the autofeed roller bearing surface. This will ex- tend the life of the bearings and keep them free to operate properly.

Machine Storage

WARNING Motor-driven equipment must be kept in- doors or well covered in rainy weather. Store the drain cleaner in a locked area that is out of reach of children and people unfamiliar with drain cleaners. This machine can cause serious injury in the hands of untrained users.

Service and Repair

Service and repair work on this Drain Cleaner must be performed by qualified repair personnel. Machine should be taken to a RIDGID Independent Authorized Service Center or returned to the factory. All repairs made by Ridge service facilities are warranted against defects in material and workmanship.

WARNING When servicing this machine, only iden- tical replacement parts should be used. Failure to follow these instructions may create a risk of electrical shock or other serious injury.

If you have any questions regarding the service or repair of this machine, call or write to:

Ridge Tool Company

Technical Service Department

400 Clark Street

Elyria, Ohio 44035-6001

Tel: (800) 519-3456

E-mail: TechServices@ridgid.com

For name and address of your nearest Independent Authorized Service Center, contact the Ridge Tool Com- pany at (800) 519-3456 or http://www.ridgid.com

14 Ridge Tool Company