Remote Controller Installation
Mounting on the wall
1. | Determine a suitable location for the |
| controller. |
2. | Make three holes in the wall as shown. |
Outline of Remote
3. | Run the cable between the controller and the |
| Rinnai water heater or the controller and |
| another controller. |
4. | Remove the face plate from the remote |
| controller using a screw driver. |
5. | Connect the cable to the remote controller. |
6. | Mount the controller to the wall using the |
| holes drilled in step 2. |
securing screw
wiring hole
securing screw
Connecting to the R75LSe, R94LSe, R98LSe, and
7.Disconnect the power from the Rinnai water heater.
8.Remove the cover of the Rinnai water heater.
9.Remove the plastic cover from the PCB and electrical connections.
10.Thread the cable through the access hole at the base of the unit and connect the wires to the controller terminals on the right hand side bottom of the PCB.
11.Secure the controller cable using the clamp provided.
12.Replace plastic cover over PCB and then replace the cover of the Rinnai water heater.
REMOTE CONTROL
CONNECTION TERMINALS
REMOTE
CONTROL CABLE
CABLE CLAMP
VA Series Outdoor LS Manual | 31 |