Roberts Gorden TF-Series service manual 2004, Table Of Contents, Optional Heater Accessories

TABLE OF CONTENTS
STANDARD PARTS LIST	1
Contents of TF-Series Burner Carton	1
Contents of Core and Extension Packages	1
GENERAL SPECIFICATIONS	2
Material Specification	2
Reflectors	2
Heater Specifications	2
Ignition	2
Suspension Specifications	2
Controls Specifications	2
Gas Pressure at Manifold:	2
Dimensions:	2
Pipe Connection:	2
Gas Inlet Pressure:	2
Electrical Rating (all Models):	2
Standard Reflector	3
One Side Reflector	3
Two Side Reflectors	3
45° Tilt Reflector	4
U-Tube, Standard Reflector	4
U-Tube, Full 45°	4
U-Tube, Opposite 45° Reflector	5
2-Foot Deco Grille, 1-Foot Deco Grille and
Protective Grille	5
Lower Clearance Shield*	5
Venting	6
TF-SERIES ASSEMBLY OVERVIEW	7
Major Component Descriptions	7
TF-Series Linear Assembly Overview	8
HEATER INSTALLATION	9
Critical Hanger Placement	9
TF-Series Linear Layout Overview	10
TF-Series Linear Layout Overview
(Continued)	11
BBurner Tube Installation	12
Burner Installation	12
Tube Clamp Package Installation	13
Coupling and Tube Assembly	13
Coupling and Tube Assembly (Continued)	14
Turbulator Installation	15
Reflector Installation	15
Reflector, U-Clip and Reflector Support
Installation	16
OPTIONAL HEATER ACCESSORIES	17
TF-Series U-Tube Assembly Overview	17
TF-Series U-Tube Layout Overviews	18
TF-Series U-Tube Layout Overviews
(Continued)	19

ELBOW PACKAGE CONFIGURATION	20
Elbow Installation	20
Elbow Installation (continued)	20
Reflector Joint Installation	20
Reflector Joint Detail	21
REFLECTOR SIDE EXTENSION	22
Bracket Installation	22
Side Reflector Installation	22
LOWER CLEARANCE SHIELD INSTALLATION	23
Shield Support Strap Assembly	23
TWO-FOOT DECORATIVE GRILLE INSTALLATION..23
Grille Installation	23
Frame Shield Installation	24
Reflector Side Extension Installation	24
ONE-FOOT DECORATIVE GRILLE INSTALLATION..25
One-Foot Decorative Grille Bracket	25
Decorative Grille	25
Joint Piece and Reinforcement	25
End Piece and Reflector End Cap	26
90° Elbow	26
PROTECTIVE GRILLE INSTALLATION	27
Silicone Cap Installation	27
Grille End Cap Installation	27
Grille Installation	27
VENTING	28
Horizontal Ventilation 4" (10 cm) Pipe	28
Vertical Ventilation 4" (10 cm) Pipe	28
CFlexible Boot Installation (Single Vent)	29
Common Sidewall Venting	29
Vertical Ventilation 6" (15 cm) Pipe	30
Flexible Boot Installation (Common Vent)	30
OUTSIDE COMBUSTION AIR SUPPLY	31
Vertical Outside Air Supply	31
Horizontal Outside Air Supplly	31
GAS PIPING	32
WIRING	33
Line Voltage Thermostat Wiring	33
Low Voltage Thermostat and Relay Wiring	34
Electrical Connection to the Burner	36
INTERNAL BURNER DIAGRAM	37
THE ROBERTS GORDON® VANTAGE® TF LIMITED
WARRANTY	38

© 2004

All rights reserved. No part of this work covered by the copyrights herein may be reproduced or copied in any form or by any means - graphic, electronic, or mechanical, including photocopying, recording, taping or information storage and retrieval systems - without the written permission of Roberts-Gordon.

Printed in U.S.A.