51
Assigning MIDI Messages (EDIT Mode)
Here’s how to assign a control change message to a controller.
1Press the [ACT] button and [ ] button simultaneously.
2Slightly move the controller to which you want to assign a control
change message.
If the controller is a button, press it.
The number of the selected controller will blink in the display.
3Verify that the display, and press the [ENTER] button.
fig.lcd-controlchange.eps
4Turn the [VALUE] knob until
“CONTROL CHANGE” appears in the
display.
fig.lcd-midichannel.eps
5Press the [ENTER] button.
The display will indicate the currently
specified MIDI transmit channel.
6Use the [VALUE] knob to specify the desired MIDI transmit channel.
fig.lcd-ccnumber.eps
7Press the [ENTER] button.
The display will indicate the currently
specified control change number.
8Use the [VALUE] knob to select the desired control change number.
9Press the [ENTER] button.
The display will indicate the currently specified control change number.
10
As appropriate for the type of controller, specify the desired “Button
mode setting” (p. 55) or “Virtual center click setting” (p. 55).
Control Change Assignment
MIDI transmit channel Control change number Port Button mode
1–16 0–127 (00–7FH) PORT1 (fixed) UNLATCH, LATCH, INCREASE
A-300_500_800C_e.book 51 ページ ２０１０年２月２２日　月曜日　午後９時１３分