144
Sampling

5.

In the EXT SOURCE section of the panel, use LEVEL knob
to adjust the input level of the external source.

* If you’re using DIGITAL IN, this adjustment is not necessary.

fig.14-002

* If the volume of the external source is too high, the PEAK indicator
will light. If this occurs, turn down the LEVEL knob until the PEAK
indicator no longer lights.
* If the level of the sound to be sampled is too high, the word “CLIP”
will appear at the right of the level meter in the screen.
* Using a connection cable that contains a resistor can cause the sound
level to be low. Use a connection cable that does not contain a resistor.

6.

Press [F8 (Start)] to begin sampling.

7.

If Stop Trigger is set to MANUAL, press [F7 (Stop)] to stop
sampling.

The Sample Edit (p. 148) screen will appear.

* If you want to edit the sample, refer to p. 146.

fig.14-007_50

When you finish sampling, the sample will automatically be
added to the sample list. Press [SAMPLE LIST] to view the
sample list.

Samples you record will be lost when you turn off the
power.

If you want to keep your sample, press [WRITE] to save
it (p. 159). Samples shown as “NEW” in the sample list have not
yet been saved.

fig.14-008_50

8.

Press [EXIT] to go back to where you were before you
entered the Sampling screen.

1.

During sampling, press [F8 (Divide)].

The sample will be divided at the point where you pressed the
button, and the subsequent material will be sampled as a
sample of the next number.

* When sampling in mono, you can divide the material into a maximum
of 256 samples. When sampling in stereo, you can divide the material
into a maximum of 128 samples (L/R total 256 samples).

Sampling time

The Fantom-X contains 32 MB of memory, which allows about 6
minutes of mono or about 3 minutes of stereo sampling. If you
want to sample for a longer time than this, you must install
separately sold memory (DIMM) (p. 244, p. 246).

Dividing a Sample During

Sampling

Fantom-X678_r_e.book 144 ページ ２００５年５月１２日　木曜日　午後４時４０分