50
Playing in Patch Mode

LFO Osc 1 Pitch Depth

Specifies the depth to which the LFO will modulate the OSC1 pitch.

Value:

-63–+63

LFO Osc 2 Pitch Depth

Specifies the depth to which the LFO will modulate the OSC2 pitch.

Value:

-63–+63

LFO Osc 1 Pulse Width Depth

Specifies the depth to which the LFO will modulate the pulse width
of the OSC1 waveform.

* The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.

Value:

-63–+63

LFO Osc 2 Pulse Width Depth

Specifies the depth to which the LFO will modulate the pulse width
of the OSC2 waveform.

* The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.

Value:

-63–+63

Range (Solo synth range)

Specifies the range in which the pitch of the solo synth will vary.

Value:

2 OCTAVES, 4 OCTAVES, 8 OCTAVES

D Beam (Assignable)

By assigning a variety of functions to the D Beam controller you can
apply different effects to the sound in real time.

fig.05-020_50

For details on these settings, refer to

“Assigning a Parameter
to a Controller”

(p. 48).

Type

Specifies the function controlled by the D Beam controller.

Value
CC01–31, 33–95:

Controller numbers 1–31, 33–95

For more information about Control Change messages, please
refer to

“MIDI Implementation”

(p. 298).

Bend Up:

Raises the pitch in semitone steps (up to 4
octaves higher).

Bend Down:

Lowers the pitch in semitone steps (up to 4
octaves lower).

Start/stop:

Starts/Stops the sequencer.

TAP Tempo:

Tap tempo (a tempo specified by the interval
at which you move your hand over the D
Beam controller).

Arp Grid:

Arpeggio Grid

Arp Duration:

Adjusts the duration of each arpeggiated
note

Arp Motif:

Arpeggio Motif

Arp Oct Up:

The range in which the arpeggio is sounded
will rise in steps of an octave (maximum 3
octaves).

Arp Oct Down:

The range in which the arpeggio is sounded
will lower in steps of an octave (maximum 3
octaves).

Range Min (D Beam Range Lower)

Specify the lower limit of the range of the D Beam controller.

Value:

0–127

Range Max (D Beam Range Upper)

Specify the upper limit of the range of the D Beam controller.By
setting Range Max below Range Min you can invert the range of
change.

Value:

0–127
Fantom-X678_r_e.book 50 ページ ２００５年５月１２日　木曜日　午後４時４０分