2 Basic Operation
Specifying a location in the
1 | Press the [ | ] key to move the carriage to the present | 2 | Use the [ | ] and [ | ] keys to line up the new |
starting location for printing in the | starting location for printing with the left edge of the |
carriage.
Left edge of the carriage
|
|
|
Starting location for | edge of | |
printing in the left and | the material |
|
right direction |
|
|
|
|
|
3 Press the [BASE POINT] key.
The BASE POINT LED lights up
The origin point is set.
To release the starting location that
has been set...
•Set a new starting location in a different location.
•Press the [SETUP] key to cancel the setup for the material (making the SETUP LED go out).
- If the carriage moves away from the standby position when not printing, problems such as
out during printing may occur. For this reason, about 60 seconds after pressing the [] key to move the carriage, the carriage returns to the standby position.
Also, the carriage returns to the standby position when about 20 seconds passes during this interval after the [] and [] key is released.
If the setting could not be made in within the time limit, then do the setting over again from the beginning.
- The starting location set by pressing the [BASE POINT] key is released after printing one page.
Setting the printing area in the
* This can be set only at the time of material setup.
1 | Press the [MENU] key and [ ] key to make the |
following screen appear on the display. |
MENU
PRINT AREA
Press the [ ] key to make the following screen
2 appear on the display.
The carriage indicates the present location of the right- hand edge of the printing area.
PRINT AREA
MOVE TO
the printing area | the material |
|
|
29