3 Maintenance
3-7 When Moving the Unit...
NOTICE | When moving the unit, first carry out head washing, then secure the carriage in place. Head washing requires |
| three optionally available cleaning cartridges. |
|
|
If there is material loaded, hold down the [SETUP]
1 key for 1 second or longer to cancel setup, then remove the material (see
Press the [
] key to make the following screen
3 appear on the display.
INK CONTROL
EMPTY MODE
When the display shown in the figure appears, discard
5 the discharged ink in the drain bottle. * Be sure to discard the discharged ink.
Attempting to replace the ink while discharged ink remains may cause discharged ink to overflow from the bottle.
DISCARD
DRAIN TANK
When all ink cartridges have been removed, head
7 washing starts. Follow the messages on the display to carry out the procedure.
2 | Press the [MENU] key and [ ] key to make the |
following screen appear on the display. |
MENU
INK CONTROL
4 | Use the [ ] key to select [HEAD WASH], then press |
the [ENTER] key. |
INK CONTROL
HEAD WASH
Mount the drain bottle and press the [ENTER] key to
6 display the screen shown in the figure.
REMOVE CARTRIDGE [KCMcmY]
When the display shown in the figure appears, head
8 washing is finished.
Press the [POWER] key to switch off the sub power.
The POWER LED goes out
Messages appearing during head washing
SET
Insert a cleaning cartridge into the ink cartridge port for the flashing color.
REMOVE
INK CONTROL
HEAD WASH
When the POWER
9 LED goes out, turn off the main power switch.
Remove the cleaning cartridge from the ink cartridge port for the flashing color.
K = Black C = Cyan M = Magenta c = Light Cyan (O = Orange)
m = Light Magenta (G = Green) Y = Yellow
Continued on the next page
45