4 User's Reference

[INVALID SHEET] appears and the material cannot be detected even when the [SETUP] key is pressed

If the material loaded on the unit is transparent, then at the [SHEET TYPE] menu, select [CLEAR].

1

Press the [MENU] key and [ ] key to make the

following screen appear on the display.

MENU

SHEET TYPE

3

Use the [ ] key to select [CLEAR], then press the

[ENTER] key.

 

SHEET TYPE

 

OPAQUE CLEAR

-When the setting for [SHEET TYPE] is changed after setup for the material has been performed, the setup for the material is automatically canceled. If this happens, set up the material again.

-When using opaque material, return the [SHEET TYPE] setting to [OPAQUE].

Press the [ ] key to make the following screen

2 appear on the display.

SHEET TYPE

OPAQUE OPAQUE

Specify a printing area for the left-right direction (the

4 direction of carriage movement) that matches the width of the material. For more information, see " 2-6 Printing -- Printing at the Desired Location -- Setting the printing area in the left-right direction (the direction of carriage movement)."

When [SHEET TYPE] has been set to [CLEAR], no detection of the material is performed when material is loaded. This means it is necessary to specify a printing area that matches the actual width of the material.

When only set to [CLEAR], the printable width is set to the maximum (FJ-52: 1322 mm (52 in.), FJ-42: 1066 mm (42 in.)).

If the "INK EMPTY" message appears during setup

A cartridge has run out of ink, and printing cannot be started.

If printing data is being sent, this message is displayed and the buzzer sounds. At the same time, operation is paused and the PAUSE LED flashes. Replace the empty cartridge with a new one and press the [PAUSE] key to start printing.

58