4 User's Reference

4 User's Reference

4-1 Materials

* Use genuine media for the FJ-52/42.

Conditions for Usable Materials

A) Maximum material thickness, including base paper (peeled-off paper)

: 1.0 mm (0.039 in.) (When head is raised)

B) Maximum diameter for roll material : 180 mm (7-1/16 in.) (surface to be printed or cut must face outward)

C) Core inner diameter for roll material: 50.8 or 76.2 mm (2 in. or 3 in.)

D) Maximum weight for roll material : 20 kg (44.1 lb.)

E) Roll material with a starting edge that is not taped down

Side view of roll material

Acceptable material widths

FJ-52

210 mm to 1350 mm (8-5/16 in. to 53-1/8 in.)

FJ-42

210 mm to 1125 mm (8-5/16 in. to 44-1/4 in.)

4-2 Adjusting the Height of the Printing Head

When using material that is thick or susceptible to warping, material feed may not proceed smoothly, or the material may jam. When such material is loaded, you can adjust the height of the printing head. To adjust the height of the head, move the lever until it clicks into place at one of the positions 1 to 3 in the figure.

This should normally be left at position 1. If printing results material feed that is not smooth because of problems such as the material jamming or the head catching on the material, adjust the height of the head.

When the height of the printing head has been adjusted, it is necessary to perform bidirectional correction (only when the printing direction for [PRINT QUALITY] has been set to [BI-DIRECTION]). For more information about bidirectional correction, see "2-6 Printing - Making Corrections for Printing - Bidirectional Correction."

Height of the printing head

High

3

1Low

* Be sure that the carriage is in standby position before attempting to move the lever.

Lever

47