2 Basic Operation

When sending a material-cutting command from the computer to separate the material automatically

*When the material-cutting command has not been set to "enabled" at the computer, automatic separation of the material is not performed, even when the following setting is made.

1

2

3

Press the [MENU] key and [ ] key to make the following screen appear on the display.

MENU

AUTO SHEET CUT

Press the [ ] key to make the following screen appear on the display.

AUTO SHEET CUT

ENABLE ENABLE

Use the [ ] key to select [DISABLE], then press the [ENTER] key.

AUTO SHEET CUT

ENABLE DISABLE

The material-separating location during continuous printing

Start of the next printing operation

10 mm (3/8 in.)

End of printing

Location where separated 10 mm (3/8 in.)

Margin (value set for [PAGE MARGIN])

2-8 When Not in Use...

NOTICE When not in use, move the sheet loading lever toward the back of the unit to leave the pinch rollers in the raised state.

The pinch rollers may be deformed if allowed to remain in the lowered state.

Sheet loading lever

34