2 Basic Operation

3

4

Place the roll material on the shaft and fit the hole at the left-hand side all the way onto the left-hand media flange.

Fit the right-hand media flange all the way into the hole on the right-hand side of the roll material, and tighten the retainer screw to secure in place.

Roll material

Rear

Pass the end of the material through the unit from back

5 to front.

Line up the end of the material with the lines of reflective tape.

If the front edge of the material has been cut at an angle, pull out the material so that all of the material covers the reflective tape.

Front

Reflective tape

Front edge of the material

With the material pulled out from the roll stretched

6 taut with no slack, move the sheet loading leverRear toward LOAD.

The pinch rollers lower to hold the material in place.

Sheet loading lever

Close the front cover, and press the [SETUP] key.

7 This detects the width of the material and displays the printable width.

The SETUP LED lights up

Top menu

W 1234 mm

FINE BI-DIR

Entire material stretched taut

20