Runco 1080p manual Channel Edit, Name, Number, Input, In Menu, 18. Unlocking a Channel

Models: 1080p

1 114
Download 114 pages 1.54 Kb
Page 61
Image 61
Channel Edit

Installation

3.Select Locked from the Channel Setup menu and press ENTER to clear the check box.

Channel Edit

1.

Name

1080i16x9 nt

2.

Number

02

3.

Input

2

 

4.

In Menu

 

 

 

 

 

 

5.Auto Source NameNumberInputIn Menu5.Auto Source

6.Locked

7.Previous Channel

8.Next Channel

Clear this check box to unlock the channel

Figure 3-18. Unlocking a Channel

 

Use the Auto Setup feature of the VX-44d/-55d as a convenient starting point for

Auto Setup

calibrating the projector DVI input for optimum picture quality.

 

Note

You cannot use Auto Setup with a locked channel; you must unlock

 

it first. Refer to Unlocking Channels on page 48.

 

Auto Setup is an automated process in which the projector quickly optimizes critical display parameters such as size, position and pixel tracking, based on the type of incoming video signal. An Auto Setup allows you to quickly get the image “in the ballpark” after which you can perform further calibration, if necessary.

To perform an Auto Setup, do one of the following:

On the Theater Master Remote Control: Press FUNCS, then AUTO followed by Enter. When the Auto Setup completes, press Enter again to keep the new settings.

On the Projector Rear Keypad: Press AUTO SETUP followed by Enter. When the Auto Setup completes, press Enter again to keep the new settings.

On the DHD Controller Remote Control: Press MENU, then select Service from the Main menu. Select Display Device from the Service Menu. Finally, select Configure from the Display Device menu, then select Auto Setup.

What an “Auto Setup” Does: Auto Setup sets the following parameters to their default values:

White Level (Contrast)

Black Level (Brightness)

Pre-Calibration (Auto Input Level) (off)

Sharpness (Detail) (if video source)

Filter

Luma Delay

Runco VX-44d/-55d Owner’s Operating Manual

49

Page 61
Image 61
Runco 1080p manual Channel Edit, Name, Number, Input, In Menu, Auto Source 6.Locked 7. Previous Channel 8. Next Channel