Runco 1080p manual readjust when absolutely necessary, to using LumaCal, Installation Menu

Installation

Installation Menu ➤

	Installation
1.	Language	English
2.	Picture Orientation	Front

3.Reserved

4.Auto Power On

5.Set Date and Time

6.OSD Adjust

7.IR and Serial Adjust

8.Geometry and Color

9.Calibration and Test Patterns

0.Service Mode Option 1 Card: Empty Option 2 Card: Empty

6.It may be advantageous to go back and check the black band. Adjust the blacklevel slidebar if necessary.

Note	Readjusting the black levels affects the gain at this point; only
	readjust when absolutely necessary.

7.Repeat Steps 4 through 6 with the other two remaining primary colors. When each primary color shows one optimized black band and white (or colored) band, the input levels for this source are correctly set. Upon exiting the White Balance menu, the Clipping Detector checkbox will clear.

•Color Enable: Select which color or colors you want to see in the display. This is useful when working with color temperature white levels or black levels.

When you have finished optimizing the picture quality, lock the channel that you unlocked previously (refer to Unlocking Channels on page 48), unlock the next channel and repeat the calibration procedure. Do this for each of the remaining channels.

Select Installation from the VX-44d/-55d Main Menu to access these advanced lamp and lens configuration options:

•LumaCal™, for maintaining constant lamp brightness

•OptiCal™, to save and restore lens positions

Calibration and Test Patterns

1.Test Patterns Grid

2.Test Pattern Level 512

3.Freeze Image

4.Color Enable White

5.Odd Pixel Adjustment

6.Reserved

7.Clipping Detector

8.Level Detector

9.	Level Value	512
0.	LumaCal	Calibrate LumaCal
	OptiCal	Full
	Aspect Ratio Overlay

Calibration and Test Patterns – LumaCal (Lamp Calibration): LumaCal defines the range of power needed to maintain lamp brightness over time.

Note	For best results, allow the projector to warm up for 15 minutes prior
	to using LumaCal.

To use LumaCal:

1.Select Installation from the Main Menu.

2.Select Calibration and Test Patterns from the Installation Menu.

3.Select LumaCal from the Calibration and Test Patterns Menu.

4.Select Calibrate LumaCal to calibrate the lamp using your projector's unique specifications (recommended). Or, select Use Default Settings to undo the effects of a previous calibration.

In the event of a power failure, the projector reverts to the default LumaCal settings in which case you should re-calibrate the lamp.

LumaCal lamp calibration takes approximately two minutes.

Note

56 Runco VX-44d/-55d Owner’s Operating Manual