Runco PL-50XA Installation, Considerations, Mounting the PlasmaWall, On a Wall or Table Stand

Installation

3.3	Proper installation of your PlasmaWall will ensure the highest possible picture quality.
Installation	Whether you are installing the PlasmaWall temporarily or permanently, you should take the
Considerations	following into account to ensure that it performs optimally.
Mounting the PlasmaWall ➤	To install the PlasmaWall, you will need either an optional table stand or wall-mounting kit.
on a Wall or Table Stand	The PlasmaWall cannot be installed on its own.
	If you do decide to wall-mount the PlasmaWall, ensure that the wall-mount bracket is
	installed according to the instructions included with it. The wall must be capable of
	supporting a redundant weight factor three (3) times the weight of the display, or be
	reinforced.
	Runco recommends that this be done by a custom installation specialist.
	Note	Use only a Runco-approved wall-mount kit or table stand that is
		specifically designed for your display.

You can attach your optional mounts or stand to the PlasmaWall in either of two ways:

• While it is upright.

•As it lies flat with the screen face down. Place the protective sheet, which was wrapped around the plasma monitor when it was packaged, between the screen and your work surface to avoid scratching or otherwise damaging the screen surface.

Ambient Light ➤ In general, minimize or eliminate light sources directed at the display. Contrast ratio in your images will be noticeably reduced if light directly strikes the display, such as when a shaft of light from a window or floodlight falls on the image. Images may then appear washed out and less vibrant.

18 Runco PlasmaWall Owner’s Operating Manual