Installation

20 Runco PlasmaWall Owner’s Operating Manual

PRELIMINARY
3.4 Connections to the PlasmaWall and DHD Controller

Proceed as follows to connect the PlasmaWall to the DHD Controller, your video sources,

external controller(s) -- if present -- and AC power.

When connecting your equipment:

• Turn off all equipment before making any connections.

• Use the correct signal cables for each source.

• Ensure that the cables are securely connected. Tighten the thumbscrews on

connectors that have them.

• Use the left audio input when connecting mono audio sources.

Connecting the

PlasmaWall to the DHD

Controller

Connect the DHD Controller to the PlasmaWall as shown in Figure 3-3 and described in

the sections that follow.

Figure 3-3. Connecting the PlasmaWall to the DHD Controller

➤
PC/
RGB
DVD/HD3
EXTERNAL
CONTROL
(RS-232)
DHD Controller
RS-232
OUT
DVI
OUT
RGB-HV
OUT
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
HD1HD2
12
R/Pr G/Y B/Pb
R/Pr G/Y B/Pb H V
DVI 1 DVI 2DVI OutH/VVH
R/Pr G/Y B/Pb
HV
TRIGGERS
RS-232 Out
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
OUTPUTSINPUTSSYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Serial No
Video Processor / Controller
Model
Runco International
Union City, CA
Made In USA