Runco VX-22D manual Filter Replacement, Side Filter Access Panel

Maintenance and Troubleshooting

6.Install the new lamp module.

7.Replace the lamp cover and re-tighten all screws.

5.2

Filter Replacement

Whenever you replace the lamp – or more often if the projector is installed in an extremely dusty environment – you should also replace the filter located at the right side of the projector.

1.Loosen the four captive screws holding the filter access panel in place. Then, remove the panel.

2.Pull the filter out of the projector and discard. Do not reuse filters.

3.Insert the new filter with the pleats facing in and the foam-covered side facing out.

4.Replace the filter access panel and tighten the screws to secure it.

Side Filter

Access Panel

60 Runco VX-22d Owner’s Operating Manual