USER’S MANUAL
⑩Tighten the screws on the case.
⑪After installing the hard disk, you must format the hard disk from the setting menu.
-The first SATA cable port on the main board must be connected at all times. If a hard disk is not connected, the DVR may not operate normally (or at all).
B.Hard disk replacement
After shutting down the DVR, disconnect the power supply.
①Loosen the screws on the left, right and rear side of the DVR casing.
②Remove the cover of the main unit.
③After removing all of power/SATA cable connected to hard disk, separate hard disk bracket from the body.
④Loosen the screws on the left and right side of the bracket holding the hard disk.
⑤Separate the hard disk from the bracket holding the hard disk.
⑥In the reverse order of removing the hard disk, assemble the new hard disk.
⑦After replacing the hard disk, turn on the power of the device.
⑧Reference
-Each SATA cable must be connected to the connecting port precisely.
-Do not vertically put the hard disk in upright position or put other objects on top of the hard disk.
-When connecting/disconnecting the hard disk, do not use a motored tool.
-Refer to the following when adding/replacing the hard disk.
H.264 REAL TIME DVR
15
