Cleaning the sensor
When the air purifier is not operating, hold the left and right edges of the back cover, pull it forward slightly (①) and then lift it up (②) to separate it.
Dust sensor | ② |
Odor sensor | ① |
|
Carefully clean the lens and the odor sensor with a cotton swap.
Dust sensor 
lens 
Odor 
sensor
ENGLISH
Insert the hooks of the back cover into the grooves at the bottom of the main body (①) and press the edges of the back cover so that it fits into 8 holes(②).
② 
①
Back cover
• Do not clean the sensors using volatile substances (alcohol, acetone, etc.). Use only water.
CAUTION • If the dust sensor lens or the odor sensor is contaminated by a foreign substance (dust), the cleanness indicator of the air purifier may be stuck in the polluted state. In this case, clean the sensors.
•Clean the sensors at least once every 6 months. However, cleaning period should be different depending on the operating environment and the operating time. Therefore cleaning should be more often in places with lots of dusts.
•Cleanness indicator on the control panel may not change from polluted state when the air purifier is operating
in place with heavy dusts or smells that may be beyond its capability. (In this case, open the window to ventilate, or use the air purifier with appropriate capacity.)
•Do not use any spray type product near the air purifier.
•Turn off the power when cleaning the sensors. If you clean the sensors while the power is on, misdetection may occur from the sensor and the cleanness indicator may not work properly.
17
ACR JUPITER |
