Samsung Digimax V4000 manual Starting recording mode, Press the shutter button to capture an image

Starting recording mode

Recording a still image

1.Insert the batteries (p.17).

Insert the batteries taking note of the polarity (+ / -).

2.Insert the memory card (p.20).

3.Close the memory card cover.

4.Slide the power switch to turn on the camera.

5.Select the PROGRAM mode by rotating the mode dial.

6.Point the camera towards the subject and compose the image by using either the viewfinder or LCD monitor.

7.Press the shutter button to capture an image.

[DELETE] message may be displayed after taking a picture. Refer to p.93 for more information about [DEL. ANSWER].

PROGRAM mode

PROGRAM mode

RECORDING

NOTICE

A Blinking autofocus indicator lamp means that the camera cannot focus on the subject. Should this be the case, the camera is unable to capture an image clearly.

INFORMATION

Manner mode

Pressing the power button over 2 seconds changes the buzzer and start-up sound setting to OFF, though you have set the settings to ON. If you wish to hear the buzzer sound and start- up sound, set the [SOUND] and [S.SOUND] settings in the SETUP mode to ON.

There are two LED lamps (one green, one red) positioned next to the viewfinder.

-If the camera is in focus when you press the shutter button halfway, the green LED will illuminate and you can take an image. If the camera can focus on the subject, the autofocus frame in the center of the LCD monitor will change from white to green.

-If the red lamp illuminates, the flash can fire.

-If the red lamp blinks, the flash is being charged.

-When an image is being stored onto the memory card, the green lamp blinks slowly. When the image data has been stored, the green LED light will go out. After the green LED light has gone out, you can resume taking images.

29